Fiberglass Pad Isolation Hanger | AF
- Permanently resilient fiberglass isolator pad
- Constant natural frequency in wide load range
- Load capacities 20 lbs. to 200 lbs. (9 kg to 91 kg)
- 500% overload fail-safe assembly
Kinetics AF hangers are recommended for use in acoustically isolated ceiling systems.
Acoustical tile ceilings can be supported by AF-100 hangers to stop high frequency "buzzing" of the ceiling grid work, caused by equipment such as transformers, chillers, and other mechanical equipment sources in the audible frequency range.
Heavy ceilings of gypsum board and plaster can be supported by AF hangers to increase the sound transmission loss.
Standard AF hangers are shipped fully assembled and ready for use.
AF fiberglass hangers are specifically designed as a noise stop isolator for use in wire-supported, suspended ceiling systems. These hangers are a combination of uniquely permanent, inorganic Kinetics Fiberglass and a zinc-plated metal assembly. This creates a combination that is essentially non-corrosive in all natural environments. The incorporation of galvanized No. 12 gauge wire adapts the AF hanger directly into the standard tie wire system used by ceiling installation trades.
AF hangers are available in two (2) load ranges:
- AF-100 load range, 20-100 pounds (9-46 kg), used for light-weight acoustical tile ceilings
- AF-200 load range, 50-200 pounds (23-91 kg), used for heavy gypsum board and plaster ceilings
Both AF hangers will carry a 500% overload without failure.
Hangers shall consist of a fiberglass isolator encased in an anti short circuit reinforced steel bracket which will accommodate up to #8 suspension wire or a 1/4" (6.35 mm) bolt or screw.
The fiberglass isolator shall be 1" (25 mm) thick, precompressed, molded fiber glass composed of fiberglass produced by a multiple flame attenuation process which generates nominal fiber diameters not to exceed 0.00022" (5.6 microns) and shall have been stabilized by precompression ten (10) times to three (3) times the maximum rated load of the material used.
The hanger assembly shall be zinc-plated reinforced steel and shall carry a five (5) times maximum rated load overload without failure. Hangers shall be AF as manufactured by Kinetics Noise Control, Inc