Kinetics Noise Control - Vibration Isolation, Room Acoustics, Seismic Restraint Your source for Noise, Acoustic, Vibration and Seismic control systems, 1-877-457-2695
Home > Vibration Isolation for HVAC Systems > Neoprene Isolation Mounts and Pads > Model RD

Kinetics™

Neoprene Vibration Isolators

Model RD

Model RD

Features

Application

Kinetics Model RD neoprene isolation mounts can be used to isolate noise and high frequency vibration generated by mechanical equipment located on a grade-supported structural slab or pier.

Typical applications of Model RD neoprene isolators are limited to isolation of mechanical equipment having the lowest operating speeds of 1750 RPM when located on a grade-supported slab or pier, and include close-coupled pumps with motors of 5 H.P. or less, small vent sets, low pressure packaged airhandling units, and similar equipment types.

Model RD neoprene isolation mounts can be used for isolation of mechanical equipment specified to be supported by neoprene rubber or elastomer isolators and with tabulated minimum static deflection up to 0.50" (13 mm).

Description

Neoprene Vibration Isolators

Kinetics Model RD isolators are one-piece molded neoprene mounts with encapsulated metal inserts, are color coded to identify capacity, and have non-skid ribs on the bottom load surfaces. Each isolator incorporates two bolt-down holes on the bottom load surface and a tapped steel load top plate for attachment to the supported equipment. The neoprene is highly oil resistant and has been designed to operate within the strain limits of the isolator to provide maximum isolation and longest life expectancy possible using neoprene compounds. Model RD is designed for up to 0.5" (13 mm) deflection, available in four sizes and eleven capacities from 55 lbs. to 4,000 lbs. (25 kg to 1814 kg). Kinetics Model RD is recommended for the isolation of vibration produced by small pumps, vent sets, low pressure packaged air-handling units, etc., and is usually selected when first cost must be minimized.

Specifications

Vibration isolators shall be neoprene, molded from oil-resistant compounds, with cast-in-top steel load transfer plate for bolting to supported equipment, and a bolt-down plate with holes provided for anchoring to supporting structure. Bottom surfaces shall have non-skid ribs.

Neoprene vibration isolators shall have minimum operating static deflections as shown on the Vibration Isolation Schedule or as indicated on the project documents but not exceeding published load capabilities.

Neoprene vibration isolators shall be Model RD, as manufactured by Kinetics Noise Control, Inc.

Model RD Neoprene Isolators
AutoCAD Details
Dimensions and Capacities
RD Mount (IP Units) (S-I Units)
RD-LB Mount (IP Units) (S-I Units)
Pricing and Quotations
 Tell a Friend
MADE IN USA