Kinetics Noise Control - Vibration Isolation, Room Acoustics, Seismic Restraint Your source for Noise, Acoustic, Vibration and Seismic control systems, 1-877-457-2695
Home > Interior Room Acoustics > AF Isolation Hanger


AF Isolation Hanger

AF Isolation Hanger

Ceiling Isolation Hangers greatly improve the STC rating for the ceiling assembly by minimizing Sound/Vibration transfer

Hanger Model Load Range Maximum Deflection
AF-100 20-100 lbs (9-46 kg) 0.27" (6 mm)
AF-200 50-200 lbs (23-91 kg) 0.18" (4 mm)

Kinetics Model AF Hangers are recommended for use in acoustically isolated ceiling systems. AF Hangers are available in two (2) load ranges:

Both Model AF Hangers will carry a 100% overload without failure. Acoustical tile ceilings can be supported by Model AF-100 Hangers to stop high frequency “buzzing” of the ceiling grid work, caused by equipment such as transformers, chillers, and other mechanical equipment sources in the audio frequency range.

Heavy ceilings of gypsum board and plaster can be supported by Model AF-200 Hangers to increase the sound transmission loss. Standard Model AF Hangers are shipped fully assembled and ready to use.


Model AF fiberglass Hangers are specifically designed as a noise stop isolator for use in wiresupported, suspended ceiling systems. These hangers are a combination of uniquely permanent, fiberglass isolation pads and a zinc-plated metal assembly. This creates a combination that is non-corrosive in all typical interior environments. The incorporation of standard galvanized suspension wire adapts the Model AF hanger directly into the tie wire system used by ceiling installation trades. Hangers are typically located a maximum 48 inches on center both ways.


Hangers shall consist of a fiberglass isolator encased in a zinc-plated steel bracket which will accommodate up to No. 8 gauge suspension wire or a 1/4” (6.35 mm) bolt


AF Isolation Hangers
Dimensions and Capacities
Requires Adobe Reader 50/200 Requires Adobe Reader 50/200(m)
Pricing and Quotations
 Tell a Friend