When sound energy strikes the surface of a wall or ceiling assembly, energy is transferred into the surface sheet material in the form of bending waves. Untreated, structural vibrations propagate throughout the floor, wall and/or ceiling structures to other rooms.
Sound Damp2 utilizes constrained layer damping technology, via viscoelastic material that is applied between two layers of gypsum wallboard, plywood or oriented strand board (OSB).
Because Sound Damp2 does not require caulking guns and tubes for application, it provides installation efficiencies and better yields. Sound Damp2 is simply and evenly applied with a low-nap paint roller, reducing your installation time significantly.
One five-gallon pail of Sound Damp2 treats 370 square feet (11-1/2 4x8 drywall sheets) for a better yield over conventional tubes.
Sound Damp2 is excellent for both wood and metal frame constructions and also damps vibrations in raised floorings, platforms and stages.
With Sound Damp2, rooms become quieter for living and sleeping. Sound Damp2 dissipates structural vibrations and significantly reduces noise transmission between rooms, up to 40% compared to untreated wall assemblies.
In an ASTM E 90 independent laboratory test, Sound Damp2 delivered an STC 53 rating, which represents an 18-point gain over standard wall construction (STC 35).
Sound Damp2 can also improve sound quality within the room. Sound Damp2 can reduce partition resonances and room reverberation times. Untreated room partitions can resonate and store the sound energy, which can be re-radiated back into the listening space later in time. Walls and ceilings also reflect lower frequency sound energy back into the room. These delayed and re-emerged sounds can distort the original signal, making the room sound slow, muddy and droning. Sound Damp2 reduces re-radiated sound energy by dissipating and absorbing wave deformations that impinge upon and within the partition. Rooms sound fast, dynamic and articulate with the use of Sound Damp2 in the partition assembly.
Sound Damp2 is water soluble and has been designed for easy and efficient installation.
Sound Damp2 is applied as a thin and consistent layer on the back of the second layer of drywall (or engineered wood) by simply using a low-nap paint roller. Sound Damp2 has the consistency of toothpaste.
Fasten the second layer of sheathing (per manufacturer’s instructions) to the first layer within 10 minutes of applying Sound Damp2.
Apply Sound Damp2 between 40-120 degrees F.
Store sealed in a cool place, away from the sunlight.
ASTM E90 Test Results
- Sound Damp2: 1 layer of 5/8" drywall on receive side
- Sound Damp2: 2 layers of 5/8" drywall on receive side
Courtesy of Cote Acoustical Consulting LLC and Unique Construction LLC