Structural Steel Beam Base

Structural Steel Beam Base with FLS isolators, supporting a cooling tower


  • Standard section depths 3 in. through 12 in. (76 mm through 305 mm)
  • Structural beam members: Angles, I-Beam, WF Beam
  • Structural beam lengths as requested
  • Height saving welded-on steel isolator brackets
  • Prelocated and drilled anchor bolt holes


Kinetics Model SBB steel beam bases are specifically designed and engineered to support mechanical equipment requiring a supplemental mounting beam system. While also having integral frame stiffness between driving and driven members, when the supplemental beam base is to be supported by Kinetics vibration isolators as part of the noise and vibration isolation of the equipment.

Steel beam bases used to support mechanical equipment provide a means of attaching supporting isolators while maintaining a rigid supporting surface for the isolated equipment. And, can provide a means by which equipment can be stabilized and motion reduced by lowering the equipment center of gravity.

Typical use of Kinetics Model SBB steel beam bases, supported by Kinetics noise and vibration isolators, includes support and isolation of absorption chillers, hermetic centrifugal chillers, package boilers, cooling towers, and similar types of equipment.


Model SBB steel beam bases meet all specifications for equipment bases, and provide rigid, distortion free mounting and anchor beams for vibration isolated mechanical equipment.

Model SBB bases incorporate a structural steel beam sections, with welded-on isolator support brackets, and pre-located and drilled anchor bolt holes for bolting to equipment to be supported.

Standard Model SBB beam bases are structural steel members with minimum section depths equal to 8% of the longest span between supporting isolators, or a minimum of 6" (152 mm), whichever is greater, to assure adequate stiffness of the beam. All Model SBB bases are sized specifically for the equipment to be supported, and have equipment anchor bolt holes pre-located and drilled as required for attachment to supported equipment. Isolator brackets are sized as required for isolators to be used and loads to be supported, and are selected to assure the lowest possible mounting height of supported equipment.


Bases shall be structural beam sections, with welded- on isolator support brackets and pre-located and drilled anchor bolt holes, and shall be designed and supplied by the isolation materials manufacturer.

Beam sections shall not be structurally connected to each other. Minimum section depth of each member shall be equal to 8% of the longest span between supporting isolators, or as shown on the drawings or indicated on the project documents.

Isolator support brackets shall be welded to the structural beams as required to obtain the lowest mounting height for the supported equipment.

Structural Bases Bases shall be model SBB, as manufactured by Kinetics Noise Control, Inc.

Model SBB Structural Base

Mechanical Systems

Vibration Isolation Seismic & Wind Noise Control